Hardware Design Verification Engineer

About the role

MLTP MultiLane Test Products, a Teradyne affiliate, develops high-speed I/O test solutions for the AI and data center equipment market. It is looking for a hands-on hardware design verification engineer who will plan and run design verification testing on its high-speed electrical and optical instruments, build reliable test setups, validate prototypes against engineering requirements, identify design weaknesses and produce objective evidence that hardware is ready for qualification and release.

Key responsibilities

• Translate product and subsystem requirements into traceable hardware DVT plans, procedures, acceptance criteria and reports.
• Build, instrument and maintain prototype test setups, fixtures, cable assemblies, loads, environmental configurations and automated data-acquisition systems.
• Run functional, parametric, margin, stress, thermal, power, clock, interface, signal-integrity and fault-insertion tests at board and instrument level.
• Use oscilloscopes, DMMs, power analyzers, spectrum analyzers, VNAs, TDRs, BERTs, logic analyzers, thermal chambers and IR/temperature-acquisition equipment as needed.
• Develop Python, LabVIEW or equivalent automation for repeatable measurements, data logging, limit checking, regression and report generation.
• Perform board bring-up, rework, probing, test-point access, schematic review, failure isolation and component-level troubleshooting with design engineers.
• Document defects with reproducible conditions, logs, waveforms, photos and measured evidence, verify corrective actions and regression coverage.
• Manage DVT equipment calibration, configuration, test assets, golden units, lab safety, ESD controls and test-data integrity.
• Support compliance pre-screening, NPI builds, manufacturing-test correlation and transfer of reusable methods to operations and sustaining teams.

Required profile

• Associate degree or BS in Electrical Engineering, Electronics Engineering Technology or a related field, with experience level matched to technician or engineer classification.
• 3+ years of hands-on hardware validation, electronics test, board bring-up or failure analysis for complex electronic products.
• Ability to read schematics, datasheets, layouts, test specifications and mechanical drawings.
• Strong bench skills: safe probing, soldering/rework, instrument configuration and disciplined measurement practice.
• Working knowledge of analog, digital, power, clocking, thermal and communication interfaces.
• Ability to work with multidisciplinary and geographically distributed teams, strong communication skills and disciplined technical documentation.

Preferred qualifications

• Experience validating RF/microwave, high-speed serial, optical or test-and-measurement products.
• Python or LabVIEW automation, Git, Jira, requirements traceability and statistical data analysis.
• Familiarity with environmental, EMC pre-compliance, HALT, reliability, calibration, GR&R and production test correlation.